Tiếng Việt
Description
Disposable respirator 3M 9501+ is used for particular respirator, meets standard P2 and KN95.
Particles such as those from grinding, sanding, sweeping, sawing, bagging or processing minerals, silica, coal, iron ore, heavy metal, flour, wood, pollen and certain other substances. Liquid or non-oil based particles from sprays that do not also emit oil aerosols or vapors. Metal fumes produced from welding, brazing, cutting and other operations involving heating of metals.
Use Limitations and Warnings
1. The wearer must first be trained in the proper use and fit tested before using this respirator.
2. Do not use this respirator when concentrations of contaminants are immediately dangerous to life or health.
3. Leave the contaminated area immediately if breathing becomes difficult, or dizziness or other distress occurs.
4. Discard and replace respirator if it becomes damaged or breathing resistance becomes excessive.
5. Inspect respirator before each use to ensure it is in good working condition. Examine all the respirator parts for signs of damage including the two straps and noseclip.
6. Do not alter, wash, abuse or misuse this respirator.
7. Do not use with beards or other facial hair or other conditions that prevent a good seal between the face and the sealing edge of the respirator.
8. Can be used up to the limits specified by applicable government regulations for this product.
9. Failure to follow all instructions and warnings on the use of this respirator and/or failure to wear this respirator during all times of exposure can reduce respirator effectiveness and may result in illness or permanent disability.
10. Make sure the respirator is not crushed or squeezed by an outside force, as this may result in the deformation and damage of the respirator. Especially pay more attention when the wearer is biking, running or conducting other activities.
11. Outside forces acting upon the noseclip on the respirator may result in injury to the wearer.
Fitting Instructions
1. With nosepiece facing away from you, hold the earloop strap in each hand with the nosepiece up.
2. Position the respirator under the chin.
3. Pull each strap over the ear. Adjust the straps as comfortable as possible.
4. Place the fingertips of both hands at the top of the metal nosepiece. Mold the nosepiece to the shape of the nose bridge by pushing inwards while moving your fingertips down both sides of the nosepiece. Pinching the respirator nosepiece using only one hand may result in less effective respirator fit.
5. The seal of the respirator on the face should be checked by the wearer prior to entering the work area.
a) Cover the front of the respirator with both hands, being careful not to disturb the position of the respirator.
b) Exhale sharply. If air leaks around the nose bridge, readjust the nosepiece as described in step 4. If air leaks at the respirator edges, work the straps back along the side of your hand.
If you CANNOT achieve a proper seal, DO NOT enter the contaminated area. See your supervisor.
c) If no leakage is detected, then work may proceed. It is very important to press the nosepiece firmly to the nose bridge to form a good seal.
Contact Achison via:
- Hotline: 0913 820 539
- Email: achisonjsc@achison.com
- Industrial Solutions: www.achison.com
There are no reviews yet.